Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • MekkeMekke
    Participant
      2017-01-01 at 23:55
      Post count: 3
      #1986

      What are the critical elements to getting the original firmware (update) working?

      Is it just the serialnumber and the Realtek 8111e network card, or is there something else in the “special sauce”?

      MekkeMekke
      Participant
        2017-01-10 at 02:50
        Post count: 3
        #2062

        Anyone?

        RoellerRoeller
        Keymaster
          2017-01-11 at 10:46
          Post count: 49
          #2092

          The software wants an eth0 or eth1, and /dev/sda or /dev/hdb, etc.. (depending on if you’re loading HS3 or HS4 software). (see the other topics around here)
          I tried to virtualize the HS on Xenserver but always had problems with XenServer’s /dev/xvda1, etc. device names.

          Why don’t you try a Hyper-V first? You can just load it into Windows10.

          MekkeMekke
          Participant
            2017-01-12 at 10:44
            Post count: 3
            #2142

            Yeah, I know about running it as a VM, but was wondering about what hardware is necessary to make the original firmware running?

            As far as I can tell it is the right serialnumber and a realtek 8111 network card. Is this correct?

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.