sx3Ok, I managed to build a homeserver on Fujitsu HW but I have a problem.
My partition table is like this:
DOM SSD 8Gb
C: – Primary – Active – Freedos (boot partition)
E: – Primary – Gira FW 4.2
F: – Primary – Empty
G: – Primary – Empty
When I boot Freedos and go to the E: and run the dolinux2.bat my system reboot immdietly, no message, no nothing. Just a reboot and I’m back to Freedos on C: again, the HS never even start to run
However, if Boot the system, through a USB stick with Freedos installed on it then I’m able to run the dolinux2.bat and I get 3 double beeps and I get to the HS “main screen”
I’ve been able to make a new small project with only IP settings and transfered it to the HS with Serial-cable with no problem.
This way the HS working, but I would like to not boot from USB stick, but from the actual Freedos located on the C: of my SSD drive.
Any suggestions?